Lancia Beta Forum

Technical stuff => Transmission => Topic started by: rossocorsa on November 02, 2015, 09:31:59 PM

Title: driveshaft support bearing spec
Post by: rossocorsa on November 02, 2015, 09:31:59 PM

just in the middle of changing the shaft support bearing, I got the replacement bearing from Mark and it's C3 tolerance however the one that I've removed (and superficially seems original) is standard tolerance anyine know which it should be?

Title: Re: driveshaft support bearing spec
Post by: HFStuart on November 02, 2015, 09:53:46 PM

Alan,

C3 bearings are routinely used in applications where a standard one could be used - it's the other way around where you might run into problems. It's quite possible Lancia fitted both.

Stuart

Title: Re: driveshaft support bearing spec
Post by: rossocorsa on November 02, 2015, 09:58:42 PM

Thanks I realise there's not a huge difference but you know I'm a terminal pedant

Title: Re: driveshaft support bearing spec
Post by: HFStuart on November 03, 2015, 07:01:00 PM

I has been noted on occasion, yes ;)