Lancia Beta Forum
Technical stuff => 3D Printed Parts => Topic started by: Joe912/62 on February 12, 2026, 07:41:26 PM
-
I don’t know if the spider has this stainless trim with a rubber moulding.
I’ve printed new ones for my car.
This is a pair for the driver side.
-
Why are the photos distorted?
-
Why are the photos distorted?
Hi
I suspect you posted the photo in portrait mode, maybe try rotating the photo to landscape. I have seen this before, just a quirk of the forum software I think.
Peter
-
I don’t know if the spider has this stainless trim with a rubber moulding.
I’ve printed new ones for my car.
This is a pair for the driver side.
Hi
They look very nicely done. Would you be willing to have the STL files available to allow us to print here in the UK (non commercial) or have available in the download section?
I was hoping to make these and the earlier version available as they are often missing and very hard to find.
Peter
-
Sure how do you upload them to the download page?
-
I have uploaded the file to download section.
I haven't tried them on the car yet. I was thinking of maybe using 3M trim tape
to install them rather than screwing them on. Try them and let me know if there is any tweeking to do.
-
I found some original ones after a lot of hunting and decided on 3m tape plus one very small head black screws ( to take any extra strain) for minimal impact on the look when fitted and seems to be holding up.
C