« previous next »
Pages: 1 [2]

Author Topic: VX hill climb  (Read 14128 times)

0 Members and 1 Guest are viewing this topic.

Offline WestonE

  • Legendary Member
  • ******
  • Posts: 1962
  • Country: gb
Re: VX hill climb
« Reply #20 on: August 09, 2012, 06:09:54 PM »
Ian

I run a pair of GC 3A cams and I see 190 BHP at 7700RPM and it screams round to an 8200 soft 8500 hard rev limit so I hope you have forged bits in the bottom end? If not just fit the inlet one for 165 - 170 BHP 155 - 160 ftlbs torque and a 7200 RPM rev limit. This assumes you have higher compression pistons of at least 10:1.

Enjoy

Eric
"Slightly" modified Montecarlo
Logged

Offline ck037

  • Jr. Member
  • **
  • Posts: 20
Re: VX hill climb
« Reply #21 on: August 10, 2012, 09:47:36 AM »
Nice video ...Nice car
 :)
Logged

Offline Grundo

  • Jr. Member
  • **
  • Posts: 43
Re: VX hill climb
« Reply #22 on: October 02, 2012, 07:56:02 PM »
I had another event run on the weekend. A short twisty sprint around the coast in Wellington. The car went very well, I finished mid pack which is always good, beat a couple of WRX's but hard to compete with RX7 turbos and a starlet running 228kW at the wheels!

Here are a few pictures.
Logged
Pages: 1 [2]
« previous next »