Afternoon all, when I kitted out the garage many moons ago I put a fused spur to the workbench and a big on/off switch mounted in the workbench. This in turn energised a couple of double sockets and a few hard wired devices such as bench grinder. The idea was I could hit 1 "kill" switch and the whole bench goes dead
Roll forward a few years and I'd like to replace the big on/off with a "No Volt Release" switch. They seem to be rated at 10A so energising a few sockets might be pushing it a bit. Chance of running over 10A is miniscule, but the whole point is safety. Not against buying more than 1, but any advice on higher rated switches?
