SA Import Beta 2000 Coupe

[Ferrit]

Can anyone figure out what these settings mean for me?

Found this.  I think it means about 1.5mm toe-out front and zero on the rear.  I might take it back and ask for 10 to 20 degrees toe-in on the back.  Its based on a ave wheel size of 28.6".  185/70 13's = 23.2", so maybe nearer 20 would be nearer 3mm?  I will write that down and take it in.  Any thoughts?

[Ferrit]

yes mistake by me.  I will go back, at least the rear is easy :-)

[lancialulu]

yes mistake by me.  I will go back, at least the rear is easy :-)

I would have thought the reference point for their laser set up was on the edge of the rims so 14" use to calc toe in/out.

[Ferrit]

Silly me 14’s not 13’s so 24.2”

I am not sure how it calculates.  I will double check my comment above.  Obv I need some toe in at the back but how much in degrees I am really unsure.

[Ferrit]

Now found a calculator on line so will work it out and go back to KF with my findings

[Ferrit]

Pre-MOT and all good, real thing next weekend.  Funny he said he wouldnt check emissions.  I was hoping for a view on the idle mixture.  It smells really rich so in the end I turned it down 1/4 of a turn today, and will give it  go to Henley tomorrow.

Also found a car breaking and have managed to get the spoiler off of the front, it was cheap enough, pick it up next week.

[WestonE]

There is a central Steel bracket for the spoiler I hope you got as well

[Ferrit]

Collected the spoiler, winter job to make it look good and make some bracketry. 

I had the front bumper off (long story) and sorted the rubbers out.  They had unhooked them at the ends and the clamps were missing so bought a couple of pipe clamps for a Landrover (thanks Nigel), and they worked a treat.

https://www.johncraddockltd.co.uk/243395-genuine-double-clamp-for-fuel-or-brake-pipes.html

[WestonE]

There should be a rubber donut round that body bracket to cushion it to the body FYI.

[Ferrit]

Anyone have a picture?  I will go look on the internet.  Long gone for me..  Thanks Eric

[Nigel]

It's 10mm thick by about 25mm round, with M6 threads
both ends.
On mine, the bobbin is showing in full, but no more, both sides, just to give
you an idea of bracket positioning.